Check out Remote HD app and atv2 plugin and control your Apple TV 2 with the iPhone/iPad/iPod touch. Install nitoTV or aTV Flash (black) to get the access to further enhancements.ģ. Step 5: Open iTunes and restore your Apple TV (Shift + ‘Restore’ button) from the created custom IPSW file (located in My Documents -> Seas0nPass).ġ. Step 4: A message will appear giving you further instructions. Step 3: When prompted, connect your Apple TV using a micro-USB cable (leave power disconnected), and hold both the ‘MENU’ and ‘PLAY/PAUSE’ buttons for 7 seven seconds. Step 2: The latest Apple TV software will be downloaded and used to create a custom jailbroken software file. Step 1: Launch Seas0nPass and select ‘Create IPSW’. A micro USB cable will be required to complete the jailbreak.Make sure you’re running the latest version of iTunes.(Don't worry there is ample to do this, so you don't need Superman speed). Once the you receive the success message shown below, the USB cable should be removed and HDMI cable connected before the light on the front of the Apple TV stops flashing. Once complete, remove the USB cable and connect the HDMI cable. when it gets to the part that says hold the Menu and Play/Pause button for 7 seconds it comes back and says 'Error Entering DFU mode this device is not supported by Seas0nPass. ipsw 5.03 firmware which i do see and tried to load. Step 3: Seas0nPass will complete the tethered boot automatically. From my understanding Seas0nPass has the. Once both are connected hold both the 'MENU' and 'PLAY/PAUSE' buttons for 7 seven seconds. Wait for the rapid flashing light then connect the power cable. Step 2: When prompted, connect the Apple TV to your computer via USB. Step 1: Open Seas0nPass and select the 'Boot Tethered' option. Note 2: The Apple TV MUST be disconnected from the computer (for at least a brief moment) after restoring for the tethered boot process below to work properly. ![]() This means the Apple TV must be connected to a computer for a brief moment during startup. Some Apple TV software versions require a tethered boot. Note: To confirm the jailbreak was successful a (temporary) red FC logo will appear in place of the Settings icon - as shown below. Step 5: Seas0nPass will complete the restore automatically, and confirm when complete. Step 4: The latest Apple TV software will be downloaded and used to create a custom 'jailbroken' software file. The older, white (plastic) remotes will not work. Note: This step will require the silver (aluminum) Apple TV remote that was included with the ATV2. Once the light on the front of the Apple TV begins to flash rapidly, point the remote at the Apple TV and hold both the MENU and PLAY/PAUSE buttons for 7 seven seconds. Step 3: When prompted, connect your Apple TV to your Mac/PC using a micro-USB cable (leave power cable disconnected). Step 2: Select the 'Create IPSW' button to start the jailbreak process. Step 1: Unzip the 'Seas0nPass.zip' file and launch Seas0nPass. Using Seas0nPass to jailbreak the Apple TV
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |